Eastwood Powder Coat Gray Primer

Enhance durability of powder-coated finishes with this epoxy-based primer.

Eastwood Powder Coat Gray Primer - EW10301LB

Priming with Powder - The legendary durability of powder-coated finishes is further enhanced with this epoxy based powder primer. If the utmost corrosion resistance and adhesion are important to you, you'll want to use this primer under every opaque powder we sell. (Not for use under our translucent finishes.) For best results apply to clean bare metal and place in a preheated 400℉ oven until flow out occurs. DO NOT cure beyond flow out as adhesion will be adversely affected. Remove from oven, cool, apply powder of choice and bake as normal.

Allowing the Epoxy powder primer to fully cure will cause poor adhesion of the top coat. Some degree of adhesion can be restored to fully cured epoxy primer by sanding with 220 grit paper, however adhesion is always best when the top coat is applied over the partially cured primer surface.

Eastwood Powders are far superior to liquid coatings. They provide an extremely durable finish that is chip resistant. All Powders are formulated of the highest quality materials and are chemical and fuel resistant. Eastwood Powders are durable enough for under hood applications and heat resistant up to 250℉. They are suitable for any metal surface and most cure at a temperature of 400℉ at 20 minutes after flow out. With Eastwood powders, you can be assured of high transfer efficiency and brilliant colors.

Powder Coating 101

Powder coating is becoming increasingly popular as a nearly indestructible alternative to regular paint. In this video we go over everything that a beginner needs to know when they start powder coating! From safety supplies to getting you the right powder coating system we make starting this process easy.

HD version of this video can be downloaded here

Application

CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.

COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11678.

CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.

Specification

Color: Gray
Gloss Level: Flat 3±2
Cure Temperature: 400℉
Cure Time: 20 Minutes after flowout
Powder Type: Epoxy
Finish: Smooth
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.

Safety

When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.

Silver Argent Rally Wheel Paint from Eastwood

This Silver Argent Paint from Eastwood has the correct tone, sheen and appearance of many original wheels. Rally Wheel Silver is appropriate for styled steel wheels, especially Muscle-Era cars. High solids content; one can covers 6 sq. ft. or two to four wheels, depending on the application. Acrylic Lacquer formulation. 50-60% gloss. Max temp 250 degrees F.

Wet powder coating method for cast bullets

This is how I coat my lead cast bullets with powder coat. I never had much luck with the dry tumbling method so I tried and eventually came out with this. Many round down the barrel I decided to share it.


  • Great stuff!
    Great product and it's easy to work with. This primer goes under almost every powder I do.

Write a Review

Product Feedback

1    2    3    4    5
Name *
Email *
Phone *
Product Name
Comment *