Wurth Dry lubricant spray PTFE - 300 ml Aerosol

Extremely durable, chip-resistant finish; coat and cure in under an hour.

Wurth Dry lubricant spray PTFE - 300 ml Aerosol

Wurth PTFE Dry Lubricant is a transparent, non-contaminating lubricant for use on metal, plastic and rubber.

Wurth PTFE Dry Lubricant is for dry lubrication of sliding parts where oils, greases and similar materials would cause soiling.

It provides a transparent, non-soiling, anti-friction coating.

Use Wurth PTFE Dry Lubricant as a dry application lubricant where dirt and other substances will not stick to the worked area.

It is resistant against water, gasoline, oil, weak acids and alkalies. Film thickness of 0.01 mm allows use even with the small tolerance on precision engineering.

Drying time is 5 to 10 minutes and hardening time is 30 minutes. It can be used as a separation agent

Application

Application area

Suitable for dry lubrication of friction points. Can be used for metals, plastic, rubber etc. under low and medium loads.

Ideal for sliding roof and seat rails, door hinges and locks, sliding doors, window tilt mechanisms, window locks, furniture hinges, drawers, guide rails, ball bearings, electrical switches etc.

Also suitable as a release agent if applied economically.

Instructions
▶   Shake briefly before use. Spray a thin layer onto friction points or joints and allow to dry
▶   Drying time for a thin application: approx. 1 - 2 mins.
▶   Drying time for a thicker application approx. 5 mins

Specification

Dry lubrication, does not attract dirt and dust

Eliminates squeaks, creaks and stiff movement

Offers lasting wear protection

Film thickness of 10 µm

Can be used for even the smallest tolerances in precision engineering

Very high resistance
▶   Resistant to temperatures from -180℃ to +260℃ (briefly)
▶   Permanently resistant to water, acids and alkalis

Mineral-oil-free

Silicone-free

Notice


Smokers must wash their hands after use. Smoking contaminated tobacco products may cause health-related issues.

The usage instructions are recommendations based on the tests we have conducted and based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and carry out further development.

Technical Data

PRODUCT INFORMATION
msds Technical Data Sheet

The information contained herein is based on data considered accurate and reliable to the best of our knowledge and belief as of the date compiled. However no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use hereof.

MSDS

PRODUCT INFORMATION
msds Material Safety Data Sheet

The information contained herein is based on data considered accurate and reliable to the best of our knowledge and belief as of the date compiled. However no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use hereof.