Eastwood Hotcoat Powder Sea Foam Green

Product Code:

EW16052

Currently out of stock.
Please call for availability & pricing

Excludes Courier Fee

Qty:

Hotcoat Powders From Eastwood

Sea Foam Green – EW 16052

Create a high gloss neon finish with Eastwood Sea Foam Green powder coat.

Cure Time: 20 Minutes @ 400°F (actual surface temperature)
100% Virgin Powder
Gloss Level: High - 80% to 95% at 60 Degrees
Powder Type: Polyester TGIC
Storage: <80°F, well ventilated, <60% humidity

Apply alone as a single stage, or as a base for any one of our translucent candy powders for a one-of-a-kind finish!

Use Eastwood PRE Painting Prep (10041Z) to remove residual grease or oil before powder application.

Hot Coat Powders Accessories:
EW101988 - Extra Kit Bottles
EW10027 - High Temp Fiberglass Masking Tape

Share this product with Friends

Application
Why powder coat? Because it gives you one of the most economical, color-durable, and longest-lasting finishes available. You'll find powder-coated surfaces are far more resistant to chipping, scratches, fading, and wear than other finishes, and the color selection is virtually unlimited, with high and low gloss, metallic, and clear finishes available. And thanks to the UV resistance of many of the powders, colors stay bright and vibrant longer. Texture selections range from smooth surfaces to a wrinkled or matte finish, plus rough textures designed for hiding surface imperfections.
One 8-oz. bottle of powder covers the same area as 2-3 cans of spray paint, and clean-up is easy, since you can simply sweep-up the over-sprayed powder. Contains no environmentally harmful solvents. HotCoat Powder Coating System requires a 5-10psi compressed air source and dedicated electric oven (or toaster oven).

Application Note: Final appearance of Translucent and Candy powders will be affected by applied powder thickness, substrate and application techniques.

Safety
Use a disposable dust mask when handling or applying powder. Powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep up—do not vacuum—powder from the floor. Cure powder in a well-ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh cartridges when curing or inspecting flow-out progress.

Powder Coating Powder


Hotcoat Powders From Eastwood
Hotcoat Powders From Eastwood

Powder Coating Made Easy - Dual Voltage Powder Coating Gun from Eastwood