Eastwood Hotcoat Powder Mirror Red

Extremely durable, chip-resistant finish; coat and cure in under an hour.
Contact us for Pricing.

Eastwood Hotcoat Powder Mirror Red - EW10290LB

Do The Job Right with Eastwood Powders!

▶   Provides extremely durable finish
▶   Contains no environmentally harmful solvents
▶   100% Virgin powder
▶   Impact resistant and flexibility
▶   Good chemical resistance

Eastwood Powders are far superior to liquid coatings. They provide an extremely durable finish that is chip resistant. All Powders are formulated of the highest quality materials and are chemical and fuel resistant. Eastwood Powders are durable enough for under hood applications and heat resistant up to 250℉. They are suitable for any metal surface and most cure at a temperature of 400℉ at 20 minutes after flow out. With Eastwood powders, you can be assured of high transfer efficiency and brilliant colors.


CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.

COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11678.

CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.


Color: Mirror Red
Gloss Level: Gloss 90±5
Cure Temperature: 40℉
Cure Time: 20 Minutes after flowout
Powder Type: Polyester
Finish: Smooth
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.


When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.

Other Colours

Select Powder Range to see


Powder Coating Made Easy - Dual Voltage Powder Coating Gun from Eastwood

With our dual-voltage HotCoat gun, you can powder coat interiors and hard-to-reach corners using the low 15,000-volt setting, or switch to the high 25,000-volt setting for multi-coat coverage over larger areas with increased powder adhesion and minimal overspray. Either way, you'll get all the benefits of powder coating in your own shop!

Extremely durable finish
Coat and cure in under an hour!
Easy to apply
Quick color changes

  • Awesome Red!!!
    I bought this while searching for a suitable color for my valve covers. All I can say is that this red looks killer & lays down very smoothly!!!
    I've already done three covers in this color & it really pops!!
  • Very Cool!
    This is a great shade of red that really pops! It's very eye catching and really hard to miss. If you need or want a part to really stand out and want to go with red, this is probably the red you're looking for!
  • Should be named Killer Red
    I was at first just going to have the rear calipers done by a powder coating shop in town in a flat black. But they wanted $300 so for a little more I bought the gun, stand and oven The front Wilwoods were black anodized that was fading to purplish black so decided on the Mirror Red for both. The fronts I used high heat decals and the high gloss clear over that. The rears are a stock brake I wanted to dress up a bit so leveled and polished the fins masked then shot the Red removed the masking after flow out, cured then re polished and cleaned then shot the high close clear over to protect the polished fins. Not perfect but decent enough for my first project. So glad I bought the Eastwood powder coat system system.