Eastwood Hotcoat Powder Squirrel Gray
Squirrel Gray – EW 16250
Do The Job Right with Eastwood Powders!
Provides extremely durable finish
Contains no environmentally harmful solvents
100% Virgin powder
Impact resistant and flexibility
Good chemical resistance
Eastwood Powders are far superior to liquid coatings. They provide an extremely durable finish that is chip resistant. All Powders are formulated of the highest quality materials and are chemical and fuel resistant. Eastwood Powders are durable enough for under hood applications and heat resistant up to 250 degrees F. They are suitable for any metal surface and most cure at a temperature of 400 degrees F at 20 minutes after flow out. With Eastwood powders, you can be assured of high transfer efficiency and brilliant colors.
Color: Squirrel Gray
Gloss Level: Gloss 80+
Cure Temperature: 400 Degrees
Cure Time: 20 Minutes after flowout
Powder Type: Polyester TGIC
RAL Number: 7000
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.
When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.
CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.
CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.
Share this product
Powder Coating Powder
Why powder coat? Because it gives you one of the most economical, color-durable, and longest-lasting finishes available. You'll find powder-coated surfaces are far more resistant to chipping, scratches, fading, and wear than other finishes, and the color selection is virtually unlimited, with high and low gloss, metallic, and clear finishes available. And thanks to the UV resistance of many of the powders, colors stay bright and vibrant longer. Texture selections range from smooth surfaces to a wrinkled or matte finish, plus rough textures designed for hiding surface imperfections.
One 8-oz. bottle of powder covers the same area as 2-3 cans of spray paint, and clean-up is easy, since you can simply sweep-up the over-sprayed powder. Contains no environmentally harmful solvents. HotCoat Powder Coating System requires a 5-10psi compressed air source and dedicated electric oven (or toaster oven).
Use a disposable dust mask when handling or applying powder. Powder, like common flour, can be explosive when suspended in the air in high concentrations. To minimize any explosion risk, sweep up—do not vacuum—powder from the floor. Cure powder in a well-ventilated area. The urethane powders we sell liberate a very minute amount of isocyanates when the powder flows out. This usually occurs about 3-5 minutes after the part is placed in the oven to bake. Wear a respirator with fresh cartridges when curing or inspecting flow-out progress.
Powder Coating Made Easy - Dual Voltage Powder Coating Gun from Eastwood