|
|
|
|
|
 |
DIRECT TO
RUST METAL PAINT
USAGE GUIDE |
|
 |
Preparation |
| |
 |
Remove all loose
rust, dirt, grease and salt with Hammerite Brush
Cleaner & Thinners and rinse with clean water. Allow
time to dry. |
|
|
For painted metal
surfaces wash down thoroughly with diluted
detergent, rinse with clean water and allow to dry.
Paint a small test patch on the painted surface to
ensure compatibility with existing paint. Any
reaction will occur within the hour. If there is,
remove all paint then wash down with degreaser.
Rinse with clean water and allow to dry. |
|
|
For smooth metal
surfaces, lightly abrade for maximum adhesion. |
|
|
On bare zinc,
aluminium and galvanized metal surfaces use
Hammerite Special Metals Primer before applying
Hammerite Direct To Rust Metal Paint. |
|
| |
Note: Special
precautions should be taken to avoid inhalation of dust
during surface preparation of pre-1960's paint surfaces as
they may contain harmful lead. |
 |
Application |
| |
|
|
Please refer to
back of pack for specific application instructions. |
|
 |
Cleaning & Storage |
| |
Remove as
much paint as possible from equipment before cleaning. For
best results use Hammerite Brush Cleaner & Thinners.
Hammerite should be stored in a dry well ventilated area.
Protect from frost and direct sunlight. DO NOT EMPTY PAINT
INTO DRAINS OR WATERCOURSES. |
 |
Tools Required |
| |
Blunt
screwdriver or old knife, wire brush or coarse sandpaper,
paint brush or roller, goggles, protective gloves, masking
tape, Hammerite Brush Cleaner & Thinners and rags. |
|
|
|
